John Deere code ECU 111.01 — Low engine coolant level detected
SPN 111 · FMI 1 · Controller ECU
What ECU 111.01 means for you
Engine power is reduced while the code is active.
Symptoms
- Code ECU 111.01 (also written ECU 000111.01) stored by the Engine Control Unit
- On tractors with this feature programmed in the ECU, the engine is derated when the switch activates.
- A warning may be shown on the machine display
Common causes
- A real operating condition: the coolant level switch reading is genuinely too low
- Faulty coolant level switch giving an incorrect reading
- Wiring or connector fault affecting the coolant level switch signal
Tune it yourself
Add John Deere machine tuning to your workshop. We supply the tools and the file, and you keep the profit.
Start tuningWhat this code means
The coolant level switch has changed state because the coolant level has dropped below its set point (FMI 1).
On John Deere skid steers: On skid steers the code sets when the switch reports low coolant while coolant temperature is high.
On John Deere tractors: On tractors the switch flips once coolant falls below a set level, and if the feature is programmed the ECU derates the engine.
In SAE J1939 terms this is SPN 111, reported with failure mode identifier (FMI) 1: the value is valid but below its normal operating range (most severe level). It is logged by the Engine Control Unit (ECU).
How a workshop diagnoses it
- Read all active and stored codes with a John Deere-compatible diagnostic tool and note related codes.
- Compare the coolant level switch reading in live data with the actual machine condition before replacing parts.
- Look for the operating cause (load, cooling, filters, supply) if the reading is genuine.
- If the real value is normal, test the coolant level switch and its wiring.
Frequently asked questions
The coolant level switch has changed state because the coolant level has dropped below its set point (FMI 1).
Severity: high. Engine power is reduced while the code is active.
Our code list records it on John Deere skid steers and John Deere tractors. The exact meaning can depend on the machine and software level, so confirm with a diagnostic read.
No. A calibration does not repair the fault behind this code. Repair the coolant level switch issue and confirm no codes remain active before the ECU is read for tuning.
Tune your John Deere
Find your John Deere in our tuning catalogue: stage 1 figures, the tool and cable for each machine, and an ECU file service for workshops.
John Deere tuning