* Estimated curve, illustrative only, not a measured dyno. Actual values will vary.
Jeep Wrangler bosch edc17cp27 / siemens/continental egs53 ECU Remap & Tuning
Vehicle
- Make
- Jeep
- Model
- Wrangler
Powertrain
- Engine
- 2.8 CRD EDC17
- Fuel
- Diesel
- Stock power
- 200 HP / 149 kW
- Stock torque
- 410 Nm
ECU Identification
- ECU
- Bosch EDC17CP27 / Siemens/continental EGS53
- KESS3 Protocols
-
- OBD2809
- Bench1233
- Boot256
- Special5026
ECU references
Known references for this ECU family on Jeep. Confirm the numbers on your ECU or readout. These are not confirmed for this exact variant and do not indicate an available tuning file.
SW / Calibration5
103751962810375196291037519910103751962768144230AA
Live ECU tuning for the Jeep Wrangler, with measured power and torque gains, a dyno preview, and the file options grouped into one focused page.
| Stock | Tuned | Gain | |
|---|---|---|---|
| Power (HP) | 200 | 235 | +35 (+18%) |
| Torque (Nm) | 410 | 520 | +110 (+27%) |
Available tuning options
Performance 2
Hard cut limiter
Tune
Towing | PowerEmissions & anti-pollution 4
DPF off We take no responsibility for legal actions as a result of disabling a DPF system, this may be illegal in your country. You must perform a forced regeneration or reset all DPF levels before reading the ECU. DPF must be removed after.
EGR off We take no responsibility for legal actions as a result of disabling a EGR system, this may be illegal in your country. If DPF is fitted we suggest not turning EGR off.
DTC off You must clear codes before writing tuned file. Not required if DPF/EGR related and DPF/EGR selected.
NOx sensor off
Driveability & comfort 3
Hot start / Cold start fix
Swirl / Intake Flaps off
Torque Monitoring off
Services, files & hardware 5
Clone ECU Must supply reads of original and new ecu's. Must bench read.
High flow turbo charger You must also select towing or power tune.
Send us your ECU Contact us to confirm ECU bench service availability and return freight before sending your ECU.
Return file to original
Checksum correction
Installation and process
Choose the tuning package that fits your goals, confirm the vehicle and ECU, and request your files. Alt Tune then guides the read, write, and verification steps for your selected vehicle — whether handled remotely with a supported flash tool or on the bench.
Support, safety, and trust
Vehicle condition, maintenance history, fuel quality, and intended use all affect results. We only publish gains we can support for the listed configuration, and we ask that you confirm suitability for your vehicle and application before ordering.
Frequently asked questions
This page describes an active entry in the Alt Tune catalogue. Which options apply depends on the control unit and the configuration actually fitted, and is confirmed after we review your file.
This vehicle shows gains of up to +35 HP and +110 Nm over the factory figures. Real-world results vary with condition and fuel.