John Deere code ECU 28.01 — Primary throttle signal extremely low
SPN 28 · FMI 1 · Controller ECU
What ECU 28.01 means for you
Most severe fault level: diagnose before continuing to work the machine.
Symptoms
- Code ECU 28.01 (also written ECU 000028.01) stored by the Engine Control Unit
- A warning may be shown on the machine display
Common causes
- A real operating condition: the primary analog throttle reading is genuinely too low
- Faulty primary analog throttle giving an incorrect reading
- Wiring or connector fault affecting the primary analog throttle signal
Tune it yourself
Add John Deere machine tuning to your workshop. We supply the tools and the file, and you keep the profit.
Start tuningWhat this code means
The primary analog throttle signal, listed as the service throttle and attributed to the foot throttle sensor, reads far below the level the ECU expects. The data is still valid but sits well under its normal range (FMI 1).
In SAE J1939 terms this is SPN 28, reported with failure mode identifier (FMI) 1: the value is valid but below its normal operating range (most severe level). It is logged by the Engine Control Unit (ECU).
How a workshop diagnoses it
- Read all active and stored codes with a John Deere-compatible diagnostic tool and note related codes.
- Compare the primary analog throttle reading in live data with the actual machine condition before replacing parts.
- Look for the operating cause (load, cooling, filters, supply) if the reading is genuine.
- If the real value is normal, test the primary analog throttle and its wiring.
Frequently asked questions
The primary analog throttle signal, listed as the service throttle and attributed to the foot throttle sensor, reads far below the level the ECU expects. The data is still valid but sits well under its normal range (FMI 1).
Severity: high. Most severe fault level: diagnose before continuing to work the machine.
Our code list records it on John Deere skid steers. The exact meaning can depend on the machine and software level, so confirm with a diagnostic read.
No. A calibration does not repair the fault behind this code. Repair the primary analog throttle issue and confirm no codes remain active before the ECU is read for tuning.
Tune your John Deere
Find your John Deere in our tuning catalogue: stage 1 figures, the tool and cable for each machine, and an ECU file service for workshops.
John Deere tuning