Black Friday Sale Save up to 41% on KESS3 activations and bundles Ends 12 Jan 2027 Shop the deals
Skip to main content

John Deere code ECU 28.03 — Throttle input voltage above range

SPN 28 · FMI 3 · Controller ECU

ECU 28.03 Severity Moderate

What ECU 28.03 means for you

Diagnose soon: the affected function may not work correctly while the code is active.

Symptoms

  • Code ECU 28.03 (also written ECU 000028.03) stored by the Engine Control Unit
  • A warning may be shown on the machine display

Common causes

  • Signal wire of the throttle input circuit shorted to a supply or battery voltage
  • Open ground or reference circuit for the throttle input circuit
  • Damaged, wet or corroded connector on the throttle input circuit circuit
  • Failed throttle input circuit

Tune it yourself

Add John Deere machine tuning to your workshop. We supply the tools and the file, and you keep the profit.

Start tuning

What this code means

The ECU measures a voltage on the primary throttle input that exceeds the sensor's upper limit, indicating a circuit fault on the throttle signal (FMI 3, voltage above normal).

On John Deere skid steers: On skid steers the fault concerns the service throttle circuit at connector X9, whose voltage reads above normal.

In SAE J1939 terms this is SPN 28, reported with failure mode identifier (FMI) 3: the circuit voltage is above normal, or the circuit is shorted to a higher voltage source. It is logged by the Engine Control Unit (ECU).

How a workshop diagnoses it

  1. Read all active and stored codes with a John Deere-compatible diagnostic tool and note related codes.
  2. Inspect the throttle input circuit connector and harness for damage, moisture, corrosion or chafing.
  3. With a multimeter, check supply, ground and signal at the throttle input circuit connector against the service specification.
  4. Check the circuit for shorts to ground or to voltage and for continuity back to the controller.
  5. Replace the throttle input circuit only after the wiring checks pass, then clear the code and retest.

Frequently asked questions

01 What does John Deere code ECU 28.03 (000028.03) mean?

The ECU measures a voltage on the primary throttle input that exceeds the sensor's upper limit, indicating a circuit fault on the throttle signal (FMI 3, voltage above normal).

02 Is John Deere code ECU 28.03 serious?

Severity: medium. Diagnose soon: the affected function may not work correctly while the code is active.

03 Which John Deere machines can show ECU 28.03?

Our code list records it on John Deere skid steers and John Deere tractors. The exact meaning can depend on the machine and software level, so confirm with a diagnostic read.

04 Will an ECU remap clear code ECU 28.03?

No. A calibration does not repair the fault behind this code. Repair the throttle input circuit issue and confirm no codes remain active before the ECU is read for tuning.

Tune your John Deere

Find your John Deere in our tuning catalogue: stage 1 figures, the tool and cable for each machine, and an ECU file service for workshops.

John Deere tuning
John Deere tractor working in a field
Photo: Ronnie Robertson / CC BY-SA 2.0

← All John Deere fault codes