Black Friday Sale Save up to 41% on KESS3 activations and bundles Ends 12 Jan 2027 Shop the deals
Skip to main content

John Deere code ECU 29.03 — Secondary throttle voltage above range

SPN 29 · FMI 3 · Controller ECU

ECU 29.03 Severity Moderate

What ECU 29.03 means for you

Diagnose soon: the affected function may not work correctly while the code is active.

Symptoms

  • Code ECU 29.03 (also written ECU 000029.03) stored by the Engine Control Unit
  • A warning may be shown on the machine display

Common causes

  • Signal wire of the secondary throttle circuit shorted to a supply or battery voltage
  • Open ground or reference circuit for the secondary throttle circuit
  • Damaged, wet or corroded connector on the secondary throttle circuit circuit
  • Failed secondary throttle circuit

Tune it yourself

Add John Deere machine tuning to your workshop. We supply the tools and the file, and you keep the profit.

Start tuning

What this code means

The voltage on the secondary analog throttle input rises above the sensor's upper limit, which the ECU treats as a high-voltage circuit fault (FMI 3).

On John Deere skid steers: On skid steers the secondary input is the foot throttle, foot throttle pedal B19, and its circuit voltage reads above normal.

In SAE J1939 terms this is SPN 29, reported with failure mode identifier (FMI) 3: the circuit voltage is above normal, or the circuit is shorted to a higher voltage source. It is logged by the Engine Control Unit (ECU).

How a workshop diagnoses it

  1. Read all active and stored codes with a John Deere-compatible diagnostic tool and note related codes.
  2. Inspect the secondary throttle circuit connector and harness for damage, moisture, corrosion or chafing.
  3. With a multimeter, check supply, ground and signal at the secondary throttle circuit connector against the service specification.
  4. Check the circuit for shorts to ground or to voltage and for continuity back to the controller.
  5. Replace the secondary throttle circuit only after the wiring checks pass, then clear the code and retest.

Frequently asked questions

01 What does John Deere code ECU 29.03 (000029.03) mean?

The voltage on the secondary analog throttle input rises above the sensor's upper limit, which the ECU treats as a high-voltage circuit fault (FMI 3).

02 Is John Deere code ECU 29.03 serious?

Severity: medium. Diagnose soon: the affected function may not work correctly while the code is active.

03 Which John Deere machines can show ECU 29.03?

Our code list records it on John Deere skid steers and John Deere tractors. The exact meaning can depend on the machine and software level, so confirm with a diagnostic read.

04 Will an ECU remap clear code ECU 29.03?

No. A calibration does not repair the fault behind this code. Repair the secondary throttle circuit issue and confirm no codes remain active before the ECU is read for tuning.

Tune your John Deere

Find your John Deere in our tuning catalogue: stage 1 figures, the tool and cable for each machine, and an ECU file service for workshops.

John Deere tuning
John Deere tractor working in a field
Photo: Ronnie Robertson / CC BY-SA 2.0

← All John Deere fault codes