John Deere code ECU 103.05 — Turbo speed sensor current low, open circuit
SPN 103 · FMI 5 · Controller ECU
What ECU 103.05 means for you
Diagnose soon: the affected function may not work correctly while the code is active.
Symptoms
- Code ECU 103.05 (also written ECU 000103.05) stored by the Engine Control Unit
- A warning may be shown on the machine display
Common causes
- Open circuit or broken wire to the turbocharger speed sensor circuit
- Disconnected or loose connector at the turbocharger speed sensor circuit
- Failed coil or internal open circuit in the turbocharger speed sensor circuit
Tune it yourself
Add John Deere machine tuning to your workshop. We supply the tools and the file, and you keep the profit.
Start tuningWhat this code means
The ECU measures too little current in the wiring of the turbocharger speed sensor. Resistance in that circuit is too high, which points to an open circuit (FMI 5).
On John Deere skid steers: On skid steers the description matches: low current caused by high resistance, which means an open circuit.
In SAE J1939 terms this is SPN 103, reported with failure mode identifier (FMI) 5: the current is below normal, or the circuit is open. It is logged by the Engine Control Unit (ECU).
How a workshop diagnoses it
- Read all active and stored codes with a John Deere-compatible diagnostic tool and note related codes.
- Inspect the turbocharger speed sensor circuit connector and harness for damage, moisture, corrosion or chafing.
- With a multimeter, check supply, ground and signal at the turbocharger speed sensor circuit connector against the service specification.
- Check the circuit for shorts to ground or to voltage and for continuity back to the controller.
- Replace the turbocharger speed sensor circuit only after the wiring checks pass, then clear the code and retest.
Frequently asked questions
The ECU measures too little current in the wiring of the turbocharger speed sensor. Resistance in that circuit is too high, which points to an open circuit (FMI 5).
Severity: medium. Diagnose soon: the affected function may not work correctly while the code is active.
Our code list records it on John Deere skid steers and John Deere tractors. The exact meaning can depend on the machine and software level, so confirm with a diagnostic read.
No. A calibration does not repair the fault behind this code. Repair the turbocharger speed sensor circuit issue and confirm no codes remain active before the ECU is read for tuning.
Tune your John Deere
Find your John Deere in our tuning catalogue: stage 1 figures, the tool and cable for each machine, and an ECU file service for workshops.
John Deere tuning