John Deere code ECU 103.06 — High current in turbo speed sensor circuit
SPN 103 · FMI 6 · Controller ECU
What ECU 103.06 means for you
Diagnose soon: the affected function may not work correctly while the code is active.
Symptoms
- Code ECU 103.06 (also written ECU 000103.06) stored by the Engine Control Unit
- A warning may be shown on the machine display
Common causes
- Short to ground in the turbocharger speed sensor circuit circuit
- Internal short in the turbocharger speed sensor circuit
- Damaged harness insulation near the turbocharger speed sensor circuit
Tune it yourself
Add John Deere machine tuning to your workshop. We supply the tools and the file, and you keep the profit.
Start tuningWhat this code means
The ECU measures more current than expected in the wiring of the turbocharger speed sensor (FMI 6, current above normal).
On John Deere skid steers: On skid steers only the excess current is reported.
In SAE J1939 terms this is SPN 103, reported with failure mode identifier (FMI) 6: the current is above normal, or the circuit is grounded. It is logged by the Engine Control Unit (ECU).
How a workshop diagnoses it
- Read all active and stored codes with a John Deere-compatible diagnostic tool and note related codes.
- Inspect the turbocharger speed sensor circuit connector and harness for damage, moisture, corrosion or chafing.
- With a multimeter, check supply, ground and signal at the turbocharger speed sensor circuit connector against the service specification.
- Check the circuit for shorts to ground or to voltage and for continuity back to the controller.
- Replace the turbocharger speed sensor circuit only after the wiring checks pass, then clear the code and retest.
Frequently asked questions
The ECU measures more current than expected in the wiring of the turbocharger speed sensor (FMI 6, current above normal).
Severity: medium. Diagnose soon: the affected function may not work correctly while the code is active.
Our code list records it on John Deere skid steers and John Deere tractors. The exact meaning can depend on the machine and software level, so confirm with a diagnostic read.
No. A calibration does not repair the fault behind this code. Repair the turbocharger speed sensor circuit issue and confirm no codes remain active before the ECU is read for tuning.
Tune your John Deere
Find your John Deere in our tuning catalogue: stage 1 figures, the tool and cable for each machine, and an ECU file service for workshops.
John Deere tuning