John Deere code ECU 100.01 — Engine oil pressure extremely low
SPN 100 · FMI 1 · Controller ECU
What ECU 100.01 means for you
Most severe fault level: diagnose before continuing to work the machine.
Symptoms
- Code ECU 100.01 (also written ECU 000100.01) stored by the Engine Control Unit
- A warning may be shown on the machine display
Common causes
- A real operating condition: the engine oil pressure reading is genuinely too low
- Faulty engine oil pressure giving an incorrect reading
- Wiring or connector fault affecting the engine oil pressure signal
Tune it yourself
Add John Deere machine tuning to your workshop. We supply the tools and the file, and you keep the profit.
Start tuningWhat this code means
The ECU reads engine oil pressure at the most severe low level (FMI 1, valid data far below the normal range).
On John Deere skid steers: On skid steers the fault is tied to oil pressure switch B5115, whose circuit voltage is under normal.
On John Deere tractors: On tractors the oil pressure signal itself is reported as extremely low.
In SAE J1939 terms this is SPN 100, reported with failure mode identifier (FMI) 1: the value is valid but below its normal operating range (most severe level). It is logged by the Engine Control Unit (ECU).
How a workshop diagnoses it
- Read all active and stored codes with a John Deere-compatible diagnostic tool and note related codes.
- Confirm the real engine oil pressure with a mechanical pressure gauge before replacing parts.
- Look for the operating cause (load, cooling, filters, supply) if the reading is genuine.
- If the real value is normal, test the engine oil pressure and its wiring.
Frequently asked questions
The ECU reads engine oil pressure at the most severe low level (FMI 1, valid data far below the normal range).
Severity: high. Most severe fault level: diagnose before continuing to work the machine.
Our code list records it on John Deere skid steers and John Deere tractors. The exact meaning can depend on the machine and software level, so confirm with a diagnostic read.
No. A calibration does not repair the fault behind this code. Repair the engine oil pressure issue and confirm no codes remain active before the ECU is read for tuning.
Tune your John Deere
Find your John Deere in our tuning catalogue: stage 1 figures, the tool and cable for each machine, and an ECU file service for workshops.
John Deere tuning