Black Friday Sale Save up to 41% on KESS3 activations and bundles Ends 12 Jan 2027 Shop the deals
Skip to main content

John Deere code ECU 100.03 — Oil pressure sensor voltage above range

SPN 100 · FMI 3 · Controller ECU

ECU 100.03 Severity Moderate

What ECU 100.03 means for you

Diagnose soon: the affected function may not work correctly while the code is active.

Symptoms

  • Code ECU 100.03 (also written ECU 000100.03) stored by the Engine Control Unit
  • A warning may be shown on the machine display

Common causes

  • Signal wire of the engine oil pressure sensor shorted to a supply or battery voltage
  • Open ground or reference circuit for the engine oil pressure sensor
  • Damaged, wet or corroded connector on the engine oil pressure sensor circuit
  • Failed engine oil pressure sensor

Tune it yourself

Add John Deere machine tuning to your workshop. We supply the tools and the file, and you keep the profit.

Start tuning

What this code means

The engine oil pressure sensor input voltage rises above the sensor's upper limit, so the ECU flags the circuit as faulty (FMI 3).

On John Deere skid steers: On skid steers the high reading is attributed to the signal being shorted to 12 V.

In SAE J1939 terms this is SPN 100, reported with failure mode identifier (FMI) 3: the circuit voltage is above normal, or the circuit is shorted to a higher voltage source. It is logged by the Engine Control Unit (ECU).

How a workshop diagnoses it

  1. Read all active and stored codes with a John Deere-compatible diagnostic tool and note related codes.
  2. Inspect the engine oil pressure sensor connector and harness for damage, moisture, corrosion or chafing.
  3. With a multimeter, check supply, ground and signal at the engine oil pressure sensor connector against the service specification.
  4. Check the circuit for shorts to ground or to voltage and for continuity back to the controller.
  5. Replace the engine oil pressure sensor only after the wiring checks pass, then clear the code and retest.

Frequently asked questions

01 What does John Deere code ECU 100.03 (000100.03) mean?

The engine oil pressure sensor input voltage rises above the sensor's upper limit, so the ECU flags the circuit as faulty (FMI 3).

02 Is John Deere code ECU 100.03 serious?

Severity: medium. Diagnose soon: the affected function may not work correctly while the code is active.

03 Which John Deere machines can show ECU 100.03?

Our code list records it on John Deere skid steers and John Deere tractors. The exact meaning can depend on the machine and software level, so confirm with a diagnostic read.

04 Will an ECU remap clear code ECU 100.03?

No. A calibration does not repair the fault behind this code. Repair the engine oil pressure sensor issue and confirm no codes remain active before the ECU is read for tuning.

Tune your John Deere

Find your John Deere in our tuning catalogue: stage 1 figures, the tool and cable for each machine, and an ECU file service for workshops.

John Deere tuning
John Deere tractor working in a field
Photo: Ronnie Robertson / CC BY-SA 2.0

← All John Deere fault codes