John Deere code ECU 100.04 — Oil pressure sensor voltage below range
SPN 100 · FMI 4 · Controller ECU
What ECU 100.04 means for you
Diagnose soon: the affected function may not work correctly while the code is active.
Symptoms
- Code ECU 100.04 (also written ECU 000100.04) stored by the Engine Control Unit
- A warning may be shown on the machine display
Common causes
- Signal wire of the engine oil pressure sensor shorted to ground
- Missing sensor supply (reference) voltage to the engine oil pressure sensor
- Chafed harness or damaged connector on the engine oil pressure sensor circuit
- Failed engine oil pressure sensor
Tune it yourself
Add John Deere machine tuning to your workshop. We supply the tools and the file, and you keep the profit.
Start tuningWhat this code means
The oil pressure sensor input voltage has dropped under the sensor's lower limit, which the ECU treats as a circuit fault (FMI 4).
On John Deere skid steers: On skid steers fitted with a pressure switch rather than a sensor, it sets when the switch reads closed at key-on with the engine stationary, pointing to a short to ground.
In SAE J1939 terms this is SPN 100, reported with failure mode identifier (FMI) 4: the circuit voltage is below normal, or the circuit is shorted to a lower voltage source. It is logged by the Engine Control Unit (ECU).
How a workshop diagnoses it
- Read all active and stored codes with a John Deere-compatible diagnostic tool and note related codes.
- Inspect the engine oil pressure sensor connector and harness for damage, moisture, corrosion or chafing.
- With a multimeter, check supply, ground and signal at the engine oil pressure sensor connector against the service specification.
- Check the circuit for shorts to ground or to voltage and for continuity back to the controller.
- Replace the engine oil pressure sensor only after the wiring checks pass, then clear the code and retest.
Frequently asked questions
The oil pressure sensor input voltage has dropped under the sensor's lower limit, which the ECU treats as a circuit fault (FMI 4).
Severity: medium. Diagnose soon: the affected function may not work correctly while the code is active.
Our code list records it on John Deere skid steers and John Deere tractors. The exact meaning can depend on the machine and software level, so confirm with a diagnostic read.
No. A calibration does not repair the fault behind this code. Repair the engine oil pressure sensor issue and confirm no codes remain active before the ECU is read for tuning.
Tune your John Deere
Find your John Deere in our tuning catalogue: stage 1 figures, the tool and cable for each machine, and an ECU file service for workshops.
John Deere tuning