Black Friday Sale Save up to 41% on KESS3 activations and bundles Ends 12 Jan 2027 Shop the deals
Skip to main content

John Deere code ECU 91.04 — Primary throttle input voltage below range

SPN 91 · FMI 4 · Controller ECU

ECU 91.04 Severity Moderate

What ECU 91.04 means for you

Diagnose soon: the affected function may not work correctly while the code is active.

Symptoms

  • Code ECU 91.04 (also written ECU 000091.04) stored by the Engine Control Unit
  • A warning may be shown on the machine display

Common causes

  • Signal wire of the primary analog throttle circuit shorted to ground
  • Missing sensor supply (reference) voltage to the primary analog throttle circuit
  • Chafed harness or damaged connector on the primary analog throttle circuit circuit
  • Failed primary analog throttle circuit

Tune it yourself

Add John Deere machine tuning to your workshop. We supply the tools and the file, and you keep the profit.

Start tuning

What this code means

The primary analog throttle input voltage falls under the sensor's lower limit, so the ECU treats the circuit as faulty (FMI 4, voltage below normal).

On John Deere skid steers: On skid steers this input is the hand throttle, hand throttle dial B18, whose circuit voltage reads below normal.

On John Deere tractors: On tractors the reading is outside its defined limits, the ECU substitutes an error value for the broadcast data, and a signal that stays low when commanded high also triggers it.

In SAE J1939 terms this is SPN 91, reported with failure mode identifier (FMI) 4: the circuit voltage is below normal, or the circuit is shorted to a lower voltage source. It is logged by the Engine Control Unit (ECU).

How a workshop diagnoses it

  1. Read all active and stored codes with a John Deere-compatible diagnostic tool and note related codes.
  2. Inspect the primary analog throttle circuit connector and harness for damage, moisture, corrosion or chafing.
  3. With a multimeter, check supply, ground and signal at the primary analog throttle circuit connector against the service specification.
  4. Check the circuit for shorts to ground or to voltage and for continuity back to the controller.
  5. Replace the primary analog throttle circuit only after the wiring checks pass, then clear the code and retest.

Frequently asked questions

01 What does John Deere code ECU 91.04 (000091.04) mean?

The primary analog throttle input voltage falls under the sensor's lower limit, so the ECU treats the circuit as faulty (FMI 4, voltage below normal).

02 Is John Deere code ECU 91.04 serious?

Severity: medium. Diagnose soon: the affected function may not work correctly while the code is active.

03 Which John Deere machines can show ECU 91.04?

Our code list records it on John Deere skid steers and John Deere tractors. The exact meaning can depend on the machine and software level, so confirm with a diagnostic read.

04 Will an ECU remap clear code ECU 91.04?

No. A calibration does not repair the fault behind this code. Repair the primary analog throttle circuit issue and confirm no codes remain active before the ECU is read for tuning.

Tune your John Deere

Find your John Deere in our tuning catalogue: stage 1 figures, the tool and cable for each machine, and an ECU file service for workshops.

John Deere tuning
John Deere tractor working in a field
Photo: Ronnie Robertson / CC BY-SA 2.0

← All John Deere fault codes