John Deere code ECU 91.15 — Primary throttle signal unavailable or slightly high
SPN 91 · FMI 15 · Controller ECU
What ECU 91.15 means for you
Least severe level: monitor and diagnose at the next opportunity.
Symptoms
- Code ECU 91.15 (also written ECU 000091.15) stored by the Engine Control Unit
- A warning may be shown on the machine display
Common causes
- A real operating condition: the primary analog throttle reading is genuinely too high
- Faulty primary analog throttle giving an incorrect reading
- Wiring or connector fault affecting the primary analog throttle signal
Tune it yourself
Add John Deere machine tuning to your workshop. We supply the tools and the file, and you keep the profit.
Start tuningWhat this code means
This code concerns the primary analog throttle signal (FMI 15). Depending on the machine, the ECU either reports the signal as unavailable or reads it slightly above its normal range.
On John Deere tractors: On tractors it means the ECU reports the primary throttle signal as not available.
In SAE J1939 terms this is SPN 91, reported with failure mode identifier (FMI) 15: the value is above its normal range (least severe level). It is logged by the Engine Control Unit (ECU).
How a workshop diagnoses it
- Read all active and stored codes with a John Deere-compatible diagnostic tool and note related codes.
- Compare the primary analog throttle reading in live data with the actual machine condition before replacing parts.
- Look for the operating cause (load, cooling, filters, supply) if the reading is genuine.
- If the real value is normal, test the primary analog throttle and its wiring.
Frequently asked questions
This code concerns the primary analog throttle signal (FMI 15). Depending on the machine, the ECU either reports the signal as unavailable or reads it slightly above its normal range.
Severity: low. Least severe level: monitor and diagnose at the next opportunity.
Our code list records it on John Deere skid steers and John Deere tractors. The exact meaning can depend on the machine and software level, so confirm with a diagnostic read.
No. A calibration does not repair the fault behind this code. Repair the primary analog throttle issue and confirm no codes remain active before the ECU is read for tuning.
Tune your John Deere
Find your John Deere in our tuning catalogue: stage 1 figures, the tool and cable for each machine, and an ECU file service for workshops.
John Deere tuning